![]() Note that the length you set must exist in your bolt catalog. Use a negative number in this field to force the length of the bolt. For an epoxy or expansion type anchor that does not use the nut and washer, the length must be set in the Cut Length field. Normally, a bolt length is calculated based on the grip (thickness of materials being bolted). When creating these bolts in the model, make sure to pick the standard you have defined, and the diameter. This creates an assdb.db file (bolt assembly catalog) that can be used in future models. Even with something like an epoxy anchor, where these are not used, they need to have a value in the Assembly.įinally, click OK and save changes to model folder. Open up the Bolt Catalog: Detailing > Bolts > Bolt Catalog. Adjust other values to choose washer and nut types. To add specialty bolts to the catalog, such as Hilti Kwik bolts follow these steps. This is the full name which is shown in the bolt assemblies list in the Bolt Assembly Catalog, and in the Bolt standard list box in the Bolt properties dialog box when invoked from the model.ĥ.It is usually the commercial name for a specific bolt. Short name is used in marking and reports.Change the properties of the bolt assembly in the right hand side. Make sure that the new name shows in the drop down at the bolt head in the picture on the right.Ĥ. Give the Hilti Kwik bolt assembly a name and click Add.ģ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |